3/22 Replaced all oil and fuel lines on both engines, checked all oil, fuel, raw water and coolant hoses, replacing any that looked worn, also all fittings
4/22 Had both sets of props re-worked and matched (spares are exact match)
4/22 Hull acid washed and polished, full bottom job, propspeed applied
7/22 new shutdown solenoids, both engines
10/22 Floscan LCD repaired
10/22 Removed KvH satellite system, installed Starlink “RV Roam” system (Spare router incl)
11/22 Replace forward AC, incl new controls/thermostat/condenser
11/22 Removed original windlass, installed new remote windlass system (Maxwell) , 200’ rode, 50’ stainless chain, new stainless plow anchor, Spare aluminum Danforth with 50’ of stainless chain and 300’ of rode mounted forward with rode in original hawse hole (out of the way and ready).
11/22 Installed Victron system, including 2 X 550 Watt Renogy solar panels, 2 Victron Multi 24 V, 3000 watt inverters with 70 Amp charger, Cerbo GX, GX touch control, Lynx Smart BMX, Lynx distributor, HD batt switch, Smartsolar MPPT 150/70 VE can, all necessary fuses and breakers, 2 x 330 AH Victron LiFePO4 12.8V batteries
Note: system will power basic AC needs for indefinite time with solar recharge. Air Con operation of 1 unit for Apx 4 hours with 25% reserve. System is fully monitored via Starlink system.
11/22 Installed Blink cameras (1X flybridge, 1X cockpit, 1X engine room/bilge) Fully live and monitored via Starlink system.
7/23 - Installed Dinghy Davit
- Added 10’ HiField Dinghy with 20 HP Tohatsu, elec start
- Modified stern door to allow access to swim platform with davit in place
- 2V elec winch for davit incl removable mount and weatherproof enclosure
- Installed 12V plugs in cockpit for deep drop and dinghy winch (Rhodan style Electra-Mate)
- Installed 12V deep cycle battery and charger in engine room for power to system
8/23 replaced water pump and fuel pump on generator, freezer fan on bait freezer
9/23 new graphic on stern
9/23 New Garmin 943 XSV including radar, Active Captain maps for SE USA and Caribbean, mounted over helm in electronics box – excellent view
11/23 New 8D house battery (1 of 2)
12/23 - Rebuilt both turbos (apx 1800 hrs at time of rebuild)
- Added Airmar B60 transducer
- Full bottom job, incl hull polish, new under water light (black oak), new spreader lights converted to DC
- Rebuilt dodger for helm, new strataglass
- Replace both main engine impellers
7/24 Complete rebuild of Vacu flush toilet system, including pump, duckbills, toilet flush, water valve and gaskets
11/24 New 8D house battery (2 of 2)
1/25 Replace cockpit bait freezer components
8/25 - Remove/repair/reinstall starboard wet exhaust pin hole leak
- New AC raw water pump, replace Forward AC blower
- Remove, clean, reinstall both heat exchangers, all new coolant, new turbo exhaust clamps
- Engine room paint touch up
- New seal and cover on helm
- Rudders re-packed, Lazarette painted
11/25 Full bottom job including propspeed and new zincs, hull polished, added support under swim platform, for dingy davit.
